![]() ![]() It is on the left-hand side of the display unit. The jump starter knob is at the front of the device. These are the steps to take to jump-start your car with the jump starter. The device has to be fully charged always. Don’t forget to charge it when you get home. Close the hood and keep the jump starter in the trunk of your car. Once your car starts, you need to deactivate the jump starter by turning the knob 90 degrees counterclockwise. On the other hand, if your car starts, let it run for at least 5 minutes before you drive away. It means there’s an underlying problem that must be solved. If your car does not start after three attempts, don’t try it again. If your car does not start, don’t crank it longer than 5 seconds. We used the jump starter to start a bus that had been left idle for more than six months, and it worked like magic. Now, you can go into your car and turn your ignition on like you always do when you want to start the car. To activate the jump starter function, just turn the jump starter knob to “on”. In our case, we connected the black clamp to the alternator of our bus, and it worked. Step 5 – Connect The Black Clamp To A Metal FrameĬonnect the black clamp to a metal frame near the battery. Connect the red clamp to the positive terminal. One is terminated with a red clamp, while the other has a black clamp. Step 4 – Connect The Red Clamp To The Positive Terminal Once you’re able to identify the positive terminal, you automatically know that the other terminal is negative. Find out which of the battery terminal is positive. Step 3 – Identify The Battery Terminalsĭon’t just connect any clamp to any battery terminal. Place the jump starter close to your battery, but it needs to stay on a flat surface so that it does not fall down when you’re cranking your car. Open the hood of your car and locate the battery. You may need to charge it before you use it. If it is not up to that, it won’t charge your car. Nevertheless, you need to check the voltage on the display unit to be sure it is fully charged. So, it will be ready anytime you need it. It is necessary to charge your jump starter after every jump-starting session. How To Use A Dewalt Jump Starter: 8 Easy Steps Step 1 – Confirm That The Jump Starter Is Fully Charged Now, let’s discuss how to use the device to jump-start your car. ![]() When the device is in jump starter mode, the battery level and voltage are displayed. You can then change the figure to your targeted pressure level. When the air compressor function is active, the pressure gauge figures will be displayed. ![]() What is displayed on the display unit depends on the active function. And press the button again to turn them off. To turn them on, just press the “Light” button. You may want to change your tire at night. You can press the Air button again to deactivate the air compressor function. It will stop automatically when it gets to the chosen pressure level. Select your preferred pressure level and connect the compressor hose to the valve of your tire. The current pressure level of your tire will appear on its display unit. To use it, you’ve got to press the Air button. You can press it again to deactivate it.Īlso, it has an air compressor with which you can inflate your tire. To activate the USB function, press the USB button once. The device has two USB ports to charge your phone, tablet, digital camera, or other smaller devices. It has other functions apart from its ability to jump-start a car. It is important to let you know that Dewalt is much more than a jump starter. This is virtually a review of Dewalt jump starter. Did you visit this page because you want to know how to use a Dewalt jump starter? Well, you’re on the right page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |